Labnet Z206A High Capacity, Compact Research Centrifuge - Manual (Page 10)

Page 10 of 24 INSTRUCTION MANUAL Z 206 A © HERMLE Labortechnik GmbH
1 PRODUCT DESCRIPTION
1.5.2 Call up of operating data
In the mode “Initial Setup“ you can call up the operating data of the centrifuge.
Please proceed as described under point 1.5.1 to enter this program mode.
Press the key “accel/decel“ (5). In the display “accel/decel“ flashes the word “service“.
By adjusting the adjusting knob (7) the information below can be called up:
A = previous starts of the centrifuge (see photo 3a)
H = previous operating hours
S
= software version
E = list of previous error messages
F
U only for service purpose
P
C
The list of the last 99 error messages can be looked over by pressing the key “rpm/rcf“ (6) and scrolling
through it by the adjusting knob (7). The respective error codes appear in the display “rpm/rcf“
(see photo 3b). Please look up in chapter 4.2.3 of this instuction manual for the detailed description.
The first two numbers (X) indicate the quantity of errors ongoing from 00 to 99, the last two numbers (Y)
indicate the error code (ex. 02 = imbalance sensor is defective).
Photo 3a Photo 3b
7 6 5
Y X