Koolance ICM-510 - Manual (Page 29)

24
Testing & Filling
Once all of the coolers have been connected, the system can be fi lled with coolant.
Swing open the ICM-510, and remove the large slot-headed screw on top of the
reservoir (with a screwdriver or large coin). Insert the refi ll funnel.
Cut a very small corner in the coolant pack, and
slowly fi ll the reservoir. You may not require the
whole pack of liquid.
WARNING : The liquid coolant is electrically conductive. Use caution
when fi lling the system, and keep all liquids away from computer
hardware and power cables. In case of emergency during installation,
immediately unplug the computer’s rear power cable. Dry the system
thoroughly before proceeding.
!
Filling & Maintenance