Koolance ERM-3K4U5 - Manual (Page 15)

10
Depending on the cooling blocks (“coolers”) in your Koolance system and tubing
sizes, they may be connected in series, parallel, or a mixture of both for best
performance. Recommended confi gurations are illustrated below.
NOTE: For simplicity, tubing ID (internal diameter) will be listed in metric units.
Please use these approximate conversions for emperical sizes:
Cooler & Tubing Confi guration
Series Tubing
For loops with only a few blocks, a simple series loop should provide the best
overall performance. For an ERM-3K4U unit, a single “loop” connects to the same
pump inlet and outlet. This confi guration can be duplicated on each pump.
Metric Emperical
6 mm 1/4 in.
10 mm 3/8 in.
13 mm 1/2 in.
Hose Adapter
“Y” Hose Splitter
10
1st System
CPU Cooler
10 10
“F” Hose Splitter
Connecting ERM-3K4U Systems
3/8” (10mm) or 1/4” (6mm) ID
Rear quick disconnect nozzles for 3/8” (10mm) internal diameter tubing are
included with the ERM-3K4U. If desired, these pump inlets and outlets can be
converted directly to 1/4” (6mm) ID lines using optional Koolance quick disconnect
nozzles. For 1U profi le computers, 1/4” (6mm) ID is recommended.
2nd System
CPU Cooler
3rd System
CPU Cooler