BenQ PB9200 - Manual (Page 38)

Multifunctional Settings 32
OPTION Menu
With the OPTION menu, the items shown in the table below
can be performed. Perform each operation in accordance
with the instructions in the table below.
(This table is continued to the following page.)
Item Description
VOLUME
Adjust the volume using the 5 / 6 buttons. :
High Low
SPEAKER
Select the TURN ON or the TURN OFF using the 5 / 6 buttons. :
TURN ON TURN OFF
When the TURN ON is selected, the built-in speaker works.
IR REMOTE
Select a remote sensor using the 5 / 6 button (1), then switch
it using the ENTER button (2). :
(1) 1 : FRONT 2 : TOP 3 : REAR (2) (Off) (On)
memo A sensor cannot be turned off when the other two are off.
Always at least one sensor is on.
IR REMOTE ID
Select a number as an ID number for remote control using the 5 /
6 buttons. :
ALL 1 2 3
The projector is controlled by the remote control whose ID
CHANGE switch is set into the position of the same number as this
number. When the ALL is selected, the projector is controlled by a
remote control irrespective of the position of the ID CHANGE
switch.
memo Please refer to the section Using The Remote ID Feature.
LAMP TIME
Pressing the RESET button for about 3 seconds displays the LAMP
TIME menu. Select the RESET using
5 button to reset the timer. :
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
memo Perform this function only when you have replaced the lamp.
The lamp timer counts the used time of the current lamp, to display
the messages about the lamp. Incorrect performing causes incorrect
operation of the messages.
memo About replacing the lamp, please refer to the section Lamp.
FILTER TIME
Pressing the RESET button for about 3 seconds displays the FILTER
TIME menu.
Select the RESET using
5 button to reset the timer. :
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
memo Perform this function only when you have cleaned or
replaced the air filter. The filter timer counts the used time of the air
filter after cleaning or replacement, to display the messages about the
air filter. Incorrect performing causes incorrect operation of the
messages.
memo About caring for the air filter, please refer to the section Air
Filter.
: SELECT
MENU
MAIN
PICTURE-1
PICTURE-2
INPUT
AUTO
SCREEN
OPTION
NETWORK VOLUME
SPEAKER
IR REMOTE
IR REMOTE ID
LAMP TIME
FILTER TIME
SERVICE
PIN LOCK 16
TURN ON
1: 2: 3:
ALL
1234 h
4321 h
TURN ON
PB9200-e.book Page 32 Thursday, May 27, 2004 2:15 PM