BenQ PB9200 - Manual (Page 31)

Multifunctional Settings 25
PICTURE-2 Menu
With the PICTURE-2 menu, the items shown in the table
below can be performed. Perform each operation in accor-
dance with the instructions in the table below.
memo This menu cannot be selected at a M1-D signal.
Item Description
V POSITION
Adjust the vertical position using the 5 / 6 buttons. :
Up Down
memo This item can be selected only at a RGB signal.
H POSITION
Adjust the horizontal position using the 5 / 6 buttons. :
Left Right
memo This item can be selected only at a RGB signal.
H PHASE
Adjust the horizontal phase to eliminate flicker using the 5 / 6 but-
tons. :
Right Left
memo This item can be selected only at a RGB signal or a compo-
nent video signal other than a COMPONENT port input of 525i/
625i/SCART RGB.
H SIZE
Adjust the horizontal size using the 5 / 6 buttons. :
Large Small
memo This item can be selected only at a RGB signal.
memo When this adjustment is excessive, the picture may not be dis-
played correctly. In such a case, please reset the adjustment pressing
the RESET button during this operation.
OVER SCAN
Adjust the over-scan ratio using the 5 / 6 buttons. :
Small Large
memo This item can be selected only at a video signal.
memo When this adjustment is too large, certain degradation may
appear at the frame area of the picture. In such a case, please adjust
small.
RESET
Select the EXECUTE using the 5 button to reset the PICTURE-2
menu items. :
EXECUTE CANCEL
The items of the PICTURE-2 menu are collectively returned to the
initial setting.
Note that the item H PHASE is not reset.
: SELECT
MENU
MAIN
PICTURE-1
PICTURE-2
INPUT
AUTO
SCREEN
OPTION
NETWORK V POSITION
H POSITION
H PHASE
H SIZE
OVER SCAN
RESET 20
142
31
1344
95
PB9200-e.book Page 25 Thursday, May 27, 2004 2:15 PM