Kisan Electronics 30W-D - Manual (Page 8)

Page - 7
20W-S INSTALLATION:
When replacing the Brake bulb with
tailBlazer, grab only the flange with
your fingers. DO NOT twist the glass
element. The single contact bulbs
have non-indexed base, so the bulb
can be inserted in any orientation.
Please identify which of the two bulbs
s for the brakes. i Replace the brake
bulb only.
20W-S is available in twin-pack.
Should there be a need to replace the 20W Halogen
element, pull the bi-pin bulb straight out from the
base. DO NOT wiggle or twist.
The sockets that hold the pins of the G-4 bulb have
beryllium copper fingers to hold the bulb tightly to
overcome vibrations. Therefore it will take some
force to remove the G-4 bulb.
CAUTION! BMW MODELS
Sockets of some of these models
may be wired wrong. Test to
make sure that the barrel of the
socket is grounded.