Kisan Electronics 30W-D - Manual (Page 16)

Page - 15
100HD-MZ INSTALLATION:
Shown is a typical
installation on a BMW.
Once you have identified
the brake and ground
wire and chosen the
correct location to make
the splice, cut and
prepare the wire ends as
shown below.
If you plan to use the rubber
boot, feed the wires though
first by piercing a small hole at
the tip of the boot.
Next, Insert the wire-ends and
screw-in (3) connections as
shown.
„ BRAKE INPUT – tap into brake wire with Scotchlock connector.
„ GROUND WIRE - interrupted by cutting & inserting ends in terminals.
Use the Velcro to mount the unit in an appropriate location – away from
high heat or direct water spray.