Kisan Electronics 30W-D - Manual (Page 6)

Page - 5
20W-D INSTALLATION:
When replacing the Tail/ Brake bulb with
tailBlazer, grab only the flange with y
fingers. DO NOT twist the glass eleme
The dual contact bulbs have indexed
pins, so the bulb can only be inserted
one way.
our
nt.
e
If you have twin dual-contact bulbs in th
taillight housing, we recommend
replacing both. 20W-D is available in
twin-pack.
Should there be a need to replace the 20W Halogen
element, pull the bi-pin bulb straight out from the
base. DO NOT wiggle or twist.
The sockets that hold the pins of the G-4 bulb have
beryllium copper fingers to hold the bulb tightly to
overcome vibrations. Therefore it will take some
force to remove the G-4 bulb.
CAUTION! Harley & Triumph
Sockets of some of these models have
been known to be: wired wrong. Test
to make sure that the barrel of the
socket is grounded, and the contacts
are wires as shown here.
AVOID ELECRICAL FIRES!