Gold wing gl-1800, 25led-d installation – Kisan Electronics 30W-D User Manual
Page 22
Page - 21
25LED-D INSTALLATION:
GOLD WING GL-1800
This unit has matching connectors
for the Honda Gold Wing GL-1800.
The inner plastic liner has to be
removed to gain access to the 2-pin
connectors of the LED spoiler.
Plug the unit in-line and attach it
with the Velcro pad supplied.
The accessory input wire MUST BE
connected to supply power to the
unit. The trunk latch-release (18-
pin) connector is a good place to
tap into. The Light Green wire with
Black stripe is s suitable source.
Wrap the scotch-lock connector on the wire then tighten it with pliers
Insert the small ring of the wire-end fully in to the slot of the scotch-lock
Please Note!
Matching connectors are for the original Hondaline spoiler only.
If you have aftermarket spoiler, you may have to discard the
connectors and make appropriate connections.
Refer to the Instructions on page 24 for:
Programming Tail light Intensity Levels