Kifco T40x1320 380,540 - 400,110 Operator Manual User Manual
Page 33
34
--Maintenance & Adjustment--
Rewind Speed Compensation Adjustment
The compensation adjustment is normally set from the factory.
1.
Place the compensator rod bolt midway in its slot on the compensator/shut off
bar.
2.
Set the desired rewind speed at the beginning of the run with the speed control
crank.
3.
As the sprinkler cart nears the end of the run (approximately 100 ft.) adjust the
compensator rod bolt in its slot to achieve the beginning of the run re-wind
speed.
A.
Move bolt and rod up in its slot to increase compensation (reduce rewind
speed)
B.
Move bolt and rod down in its slot to decrease compensation (increase
rewind speed)
Shut-off bar
Speed control crank
Compensator rod bolt
This manual is related to the following products:
- E37x1220 380,540 - 400,110 Operator Manual T37x1220 380,540 - 400,110 Operator Manual E33x1120 380,540 - 400,110 Operator Manual E30x1200 380,540 - 400,110 Operator Manual T33x1120 380,540 - 400,110 Operator Manual T30x1200 380,540 - 400,110 Operator Manual E30x980 380,540 - 400,110 Operator Manual T30x980 380,540 - 400,110 Operator Manual