Kifco T40x1320 380,540 - 400,110 Operator Manual - Manual (Page 21)

22
--Start Up--
Turbine Drive Speed Settings
Select the proper turbine/gearbox v-belt pulley and gearbox range combination. Refer to
the speed range chart for correct selection (page 17).
Caution! The belt position must be used to prevent excessive pressure
loss! The life expectancy of the turbine motor bearings and seal will be
substantially shortened if the turbine is allowed to run faster than
necessary.
With water flowing through the system and the belt position selected, adjust the speed
control crank until the desired speed is indicated on the travel speed indicator (see
illustration). Cruise Control equipped models control the speed via the keypad. See the
Cruise Control operators manual for complete instructions.
Compensator
bar
Shut
off slide stop
Rear
tube Safety bar
Compensation
Shut off rod adjustment
slide
Butterfly shaft lever
Speed control crank
Gearbox disengage knob
Travel speed indicator
(Tachometer)
Gearbox
disengage bolt
Shut off bar