Intelix AVO-A2-WP110 - Manual (Page 2)

Installation
To install the Intelix AVO-A2-WP110 balun, perform the following steps:
1. Turn off power and disconnect the audio equipment by following the manufacturer’s
instructions.
2. Make certain that outlets and cross connects to which you will connect the AVO-
A2-WP110 are configured properly and labeled correctly to identify the point-to-
point circuit.
3. Verify the desired twisted pairs are not being used for other LAN or telephony
equipment.
4. Connect the AVO-A2-WP110 to a twisted pair cable, such as Cat 5 or Cat 6. Verify
the pinout on the balun conforms to EIA/TIA 568B standards, as labeled on the
balun.
5. Mount the AVO-A2-WP110 in a standard wallbox.
6. Connect a second compatible Intelix balun to the opposite end of the twisted pair
cable. Verify the pinout on the balun conforms to EIA/TIA 568B standards.
7. Connect the RCA outputs from the source equipment to the first AVO-A2-WP110.
8. Connect the RCA inputs from the receive input to the second compatible Intelix
balun.
9. Power on the source and destination equipment and test for correct operation.
Caution: Do not attempt to disassemble or alter the balun housing. There are no
user-serviceable parts inside the unit. Doing so will void your warranty.
Caution: Do not connect the balun to a telecommunication outlet wired to
unrelated equipment. Doing so may damage the unit or any connected equipment.
Ensure all connected twisted pair cabling is straight-through (point-to-point).
Caution: When connecting twisted pair cables to the 110 punch-down connector
on the balun, care should be taken to keep the wires twisted as close to connector
as possible. This will help eliminate stray EMF interference.
Caution: Do not strip the jacket from the individual wires in the twisted pair
cable. The 110 punch-down connector will strip the wire jacket during
termination. Stripping the jacket may result in shorts.