beautypg.com

Dip switch settings, Troubleshooting – Intelix DIGI-HD-IR3-R User Manual

Page 2

background image


8001 Terrace Ave.
Suite #201
Middleton, WI 53562

Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833


DIP Switch Settings






DIGI-HD-IR3 Transmitter Dip Switch Positions

SW 1 SW 2 Mode

Off

Off

Read EDID data from displays

Off

On

1080p with multi-channel audio

On

Off

1080p with stereo audio

On

On

No function

DIGI-HD-IR3 Receiver Dip Switch Positions

SW 1 SW 2 Mode

Off

Off

Normal Operation

Off

On

Compatibility Mode

On

Off

Compatibility Mode

On

On

No function


*The DIGI-HD-IR3 system must be power cycled for the changes
to take effect. Please remove ALL cables from extender, change
DIP switches, and then reconnect.


Troubleshooting

Symptom

Possible Solutions

No signal

Status LED is off

Verify that both ends of the twisted pair cables
use 568B crimp pattern.

Verify HDMI cables and source and destination
HDMI ports are operational.

No signal

Verify the power supplies are connected to both
the send and receive baluns.

Verify the power LEDs on both the send and
receive units are brightly illuminated.

Unusual colors in the
video

Power off the destination device and power it
back on to force renegotiation.

Unplug and re-plug the HDMI cable from receive
balun to force renegotiation.

No signal

Screen is completely
snowy

Speckling in the video
image

Occasional signal dropouts

Use shorter runs of twisted pair cabling.

Drop the HDMI signal to the next lower
resolution; i.e., decrease resolution from 1080p
to 1080i, etc.

Replace the twisted pair cable with a higher
grade twisted pair cable; i.e., replace Cat 5e with
Cat 6.

Set the receive extender dipswitches to
compatibility mode.

Speckling in the video
image

If the destination device is incapable of displaying
the video signal, alter the source signal; i.e.,
decrease resolution from 1080p to 1080i, etc.

Video without audio

Change source device to output PCM other than
Bitstream audio

Enable PCM down sampling if supported by your
source device

This manual is related to the following products: