Intelix DIGI-DVI-F - Manual (Page 2)

Installation
To install the Intelix DIGI-DVI-F baluns, perform the following steps:
1. Identify the pin configuration of the baluns and RJ45 connectors on the
twisted pair cabling. To eliminate crosstalk, the pin configuration must
follow the EIA/TIA 568B standard. Please ensure that wiring is straight-
through.
2. Connect the DIGI-DVI-F send balun to the DVI output of the video
source.
3. Connect the DIGI-DVI-F receive balun to the DVI input of the receiving
device at the remote end. Do not connect the 5V power supply.
4. Complete the connection between the send and receive baluns using two
runs of twisted pair cable. Ensure that there are no split pairs or taps.
5. Connect the 5V power supply to either the send or receive DIGI-DVI-F
balun.
6. Power-on the video equipment.
7. Verify picture quality.
Warning! To minimize the possibility of equipment damage from electrostatic
discharge (ESD), all source and destination equipment must be turned off
during the installation of video equipment. This includes signal extenders,
splitters and switches.