INFICON SKY CDG045D 0.05 ... 1000Torr / mbar - Manual (Page 27)

tina51e1-c (2011-12) 27
4.3 Switching Functions
The two switching functions can be set to any pressure within
the measurement range of the gauge (
→  14).
The current setpoint setting
• can be read/written via the diagnostic port,
• is output at the D-Sub connector instead of the measurement
signal ( →  20) and can be measured with a voltmeter after
the button is pressed, or
• can be read/written via the RS232C interface.
If the pressure is lower than the setpoint, the corresponding LED
( or ) is lit solid and the corresponding relay
(
→  20) is energized.
Measurement signal (pressure p)
Time t
Me
asu
reme
nt value
Off On
Hysteresis
(1% F.S.)
Off
Threshold value
Setpoint