INFICON SQC-122C Thin Film Deposition Controller Communications Manual - Manual (Page 8)

120 Commerce Drive
•
Fort Collins, Colorado 80524
•
(970) 416-9660
•
Fax (970) 416-9330
Σ
Sigma
instruments
Get/Set Relay Parameters
Command: H
Description: Gets/Sets the logical function of each of the 16 relays.
Parameters: 1 Source 1 Shutter 13 Max. Power
2 Source 2 Shutter 14 Stopped
3 Sensor 1 Shutter 15 Time Setpoint
4 Sensor 2 Shutter 16 Thick Limit
5 All Crystals Fail 17 Final Thickness
6 Sensor 1 Fail 18-25 Pocket 1-8
7 Sensor 2 Fail 26 Dual Xtal Shutter
8 Deposit Phase 27 None
9 PreCond Phase
10 SoakHold Phase
11 Process Active
12 Manual Mode
Example: To Get Relay functions, send: H?
The return string for Sensor 1 Shutter on Relay 1, all other None would
be:
3 27 27 27 27 27 27 27
To Set the Relay 2 to Process Active you would send:
G3 11 27 27 27 27 27 27
Command: J
Parameters: None.
Description: Read the number of channels installed. The number of channels will be
either an ASCII two or six.
Example: J A2 The unit has two channels available.