INFICON UL1000 Helium leak detector Interface description - Manual (Page 8)

1-4
Interface Description
iin
s
70
e1
.fm
Op
er
at
in
g M
a
nua
l
(1
00
4)
1.7 Command list
*CLS clear Error
*IDN identification
:CRC check sum
:DEVice name of instrument (UL1000, UL1000Fab, UL5000)
:VERsion software version
:SERial serial-Number
:TURBO software version TC600
:MC68 hardware identification MC68
:IOversion hardware identification IO-Karte
:GBversion hardware identification control panel
:VDversion hardware identification mother board
:DIP1 MC68 DipSwitch 1
:DIP2 MC68 DipSwitch 2
:TURBO software version frequency converter
*STATus mode of calibration routine
INIT, ACCL, STBY, VENT, WAIT_EVAC, EVAC,
MEAS, CAL, ERROR
[:CAL] mode calibration
IDLE, EVAC, OPEN, TUNE, TUNE_RES, CLOSE,
STABLE_CLOSE, WAIT_OK
[:CALHist] CAL History (1…12)
[:CALMode] kind of calibration INT_AUTO, INT_MAN, EXT
[:ERRor] error
[:ERRorHist] error History (1…12)
[:ZERO] zero
[:RANGE] measuring mode GROSS, FINE, ULTRA
:BOOSTER
Booster-TMP State (UL5000 only): OFF, ACCL,
NORM, FAIL
:RESULT
AutoLeakTest state/result: IDLE, RUNNING, PASS,
FAIL
:TESTLog Test-Log
*READ leak rate (selected unit)
[:] leak rate (desired unit)
*STArt start
*STOp stop
*PURGE Purge on
:OFF Purge off
*VENt vent
*CAL start calibration / proceed (see Chapter 1.8)
*ZERO zero
[:OFF] zero off