Belkin F5D6230-3 - Manual (Page 66)

65
Troubleshooting
My connection type is Dynamic
IP Address. I cannot connect to the
Internet.
My connection type is PPPoE. I
cannot connect to the Internet.
2. Make sure the cable or DSL line
is properly attached on your
cable or DSL modem. Refer the
manual of your modem to verify
that it works normally.
3. Make sure the network cable
between the modem and the
router is well connected. Power
off the modem; wait a
few seconds and then power it
on again.
4. Your ISP may bind your
connection to the MAC address
of your computer’s NIC. Clone
your MAC address.
1. Since your connection type is
PPPoE, your ISP will assign you
an account name and password
and service name. Make sure the
Router connection type is
configured as PPPoE and fill these
settings are entered properly.
2. Make sure your computers are
correctly configured and all
network cables are properly
connected.
3. Make sure the coaxial cable or
DSL line is properly attached on
your cable or DSL modem. Refer
the manual of your modem to
verify it works normally.