Belkin F5D6230-3 - Manual (Page 40)

39
Step 4: Configuring your Belkin Wireless Cable/DSL Router
(the Router) for connection to the Internet
Dynamic Setup
Configuring Your Router if your Provider uses Dynamic IP Addressing
Follow this procedure if your ISP uses dynamic IP addressing. The Router's
default (factory) setting is set to dynamic. If your ISP has provided you
with a Static IP address or your provider uses PPPoE for you to connect
skip to the next section.
1. Click on “Initial Setup”. The following screen will appear:
2. Select “Dynamic IP Address” and click “Select”.
This will tell the Router that the ISP provides a dynamic IP address.
3. Click “MAC Cloning/Entry” on the left-hand side of the screen. The following
screen will appear.