HYDAC EDS 601 - Manual (Page 14)

EDS 601
Serial number:
Date:
Installation site:
Appendix B: Parameter form sheet
Switching point settings
7.
Basic settings
Measuring range settings
Notes
Note: Take a copy of this sheet and fill in your required settings. You can
keep this form sheet near your manual so that you can refer to the
particular setting options at the same time. Do not commence
programming of the EDS 601 until you are sure about all the
settings. This is especially important in the case of complex settings.
This sheet can also be used for documentation purposes.
Switching point 1 S.P.1
Switching hysteresis 1 HYS.1
Switching point 2 S.P.2
Switching hysteresis 2 HYS.2
Decimal point position POIN.
Lower measuring range limit RAN.L.
Upper measuring range limit RAN.H.
Switching direction relay 1 REL. 1
Switching delay relay 1 T. ON.
1
Switch-back delay relay 1 T. OF.
1
Switching direction relay 2 REL. 2
Switching delay relay 2 T. ON.
2
Switch-back delay relay 2 T. OF.
2
Primary display PRIM.
Display filter DISP.
E