Heidolph SilentCrusher M - Manual (Page 39)

- 39 -
E
E
To disconnect the device from the power supply system, unplug the mains plug.
When operating under pressure or in a vacuum, always position the stator shaft
with the sealed tool in the fluid so that the upper hole (TT) in the stator shaft is
always above the level of the fluid.
If the hole (TT) is below the level of the fluid, it can enter the upper range of the
dispersion tool and damage it.
Please note minimum and
maximum immersion
depth!
* minimal immersion
depth using vacuum
9.1 Speed limitation of the drive
The tools 22 F and 22 G can be operated with a maximum speed of 20,000 rpm. If this speed is
exceeded, the drive automatically limits the speed after a brief period.
The limitation to 20,000 rpm is portrayed by the blinking right decimal point on the display (DD)
and can be reset by reducing the desired speed <20,000 rpm.
With an appropriate load, speed limitation can also activate with tools <22 F/G.
10. Tool Replacement
Always disconnect the device using the switch (Y) before replacing the tool.
Standard Dispersion Tool (1)
Min. Max.
6F 20 50
8F 25 55
12F 25 80
12G 25 80
18F 25 140
18G 25 140
22F 30 140
22G 30 140
Min. Min. (vac)* Max.
8DF 25 35 50
12DF 25 35 75
12DG 25 35 75
18DF 25 35 135
18DG 25 35 135