2 setting up snmp in the lb, Setting up snmp in the lb-view box – GeoDesy FSO Giga Next series User Manual
Page 36
GeoDesy Kft.
H-1116 Budapest, Kondorfa str. 6
7.2 Setting up SNMP in the LB
Please check the LB view manual for details how to proceed to this point
On Figure 1 you can see our test setting. The LB
LaserHeadAlarm (OID:
of the alarms will go on (for alarm setting please see chapter
LaserHeadAlarmCancel
(OID:
this trap will be sent
DeviceDown (OID:
1.3.6.1.4.1.17857.0.1103) This trap is being sent when the
SNMP agent is disabled
Even if you have one laerhead attached to one L
network you can generate traps without, causing any problems, with the testing.
For these testing purposes please set Alarm1 to RS485(this will generate traps), and
Alarm2 Alarm3 to transmitter(this wont generate traps, so w
On figure 2 the settings can be seen.
Change the Trap address to the MGM console IP address which will have the
SMNPc installed
Enabled must be set to on the function will disable the SNMP
After this was set the LB view is ready to send out the Trap messages, to the Trap
Addressed PC
Telefon: 06
. 6-8.
E-mail: info@geodesy
http://www.
36
Horváth Holding
Investment PLC.
Setting up SNMP in the LB-View Box
Please check the LB view manual for details how to proceed to this point
1. Figure
On Figure 1 you can see our test setting. The LB-View is sending 3 traps
1.3.6.1.4.1.17857.0.1201) This trap will be sent after any
of the alarms will go on (for alarm setting please see chapter 5.4)
(OID: 1.3.6.1.4.1.17857.0.1202) After the alarm goes off
1.3.6.1.4.1.17857.0.1103) This trap is being sent when the
Even if you have one laerhead attached to one LB-View, or you are on the live
network you can generate traps without, causing any problems, with the testing.
For these testing purposes please set Alarm1 to RS485(this will generate traps), and
Alarm2 Alarm3 to transmitter(this wont generate traps, so wont disturb the testing)
2. Figure
On figure 2 the settings can be seen.
Change the Trap address to the MGM console IP address which will have the
Enabled must be set to on the function will disable the SNMP agent.
After this was set the LB view is ready to send out the Trap messages, to the Trap
Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
http://www.geodesy-fso.com
Horváth Holding
Investment PLC.
Please check the LB view manual for details how to proceed to this point
View is sending 3 traps
1.3.6.1.4.1.17857.0.1201) This trap will be sent after any
1.3.6.1.4.1.17857.0.1202) After the alarm goes off
1.3.6.1.4.1.17857.0.1103) This trap is being sent when the
View, or you are on the live
network you can generate traps without, causing any problems, with the testing.
For these testing purposes please set Alarm1 to RS485(this will generate traps), and
ont disturb the testing)
Change the Trap address to the MGM console IP address which will have the
agent.
After this was set the LB view is ready to send out the Trap messages, to the Trap