General Machine Products 89010 Breeze Micro Fiber Cable Blowing Machine - Manual (Page 7)

Page 7 of 43 General Machine Products Co., Inc.
2. Critical points that dramatically affect the operation of the cable blowing
machine.
 Pressure on the cable (Position of the close arm assy) should be set as per the instruc-
tions.
 Rollers to be closed at all times when cable is installed into machine.
 Cord seals in air chamber correctly fitted to provide good sealing.
 Correct cable seal fitted.
 Tube fully connected and pressure-tested.
 Tube connecting fittings are suitable for operating at 220 PSI air pressure.
 Tube clamp securely tightened.
 Compressor capacity 220 PSI and suitable for size of tube being used.
 Cable drum must be located directly behind and in line with the blowing machine.
 Air chamber, drive rollers, cable guides, must be clean and free from debris, sludge, dirt,
water and lubricant.
 The cable must be hand guided into the blowing machine through a dry clean cloth by the
operator wearing work gloves.
 Ensure the compressed air supply is not applied to the cable until approximately 165 ft of
cable have been installed or the motor begins to labor.