Flint & Walling 230V Pond and Fountain Systems FPS10021 - Manual (Page 7)

7
95 North Oak St. • Kendallville, IN 46755 • 800-742-5044 • © 2012 All rights reserved.
Floating Pond Pump System
IL0809
ON
OFF
ON
OFF
Light Timer
Power
B
Pump
Motor
Contactor
Power Load
W
H1 H2
To Lights
W
GRD GRD
To Pump To Line
P1 P2 L1 N L2
Pump Timer
Power
Power Load
B
R
B R
B/W R/B
W/B
R/B
B/W
W B R
Ground Fault
Interrupter (GFI)
Reset
Power
Test
Fault
Never
enter the
water either wading,
swimming or in a boat with
the pump power on, as this may result
in severe electrical shock.
!
This product
contains chemicals
known to the State of California to
cause cancer and birth defects or other
reproductive harm.
Hazardous voltage.
Can shock, burn
or cause death.
Ground system before
connecting to power
supply.
Electrical
installations
shall be in accor-
dance with National
Electric Code (NEC)
and all applicable
local codes and
ordinances. A
licensed electrician
should perform
installation.
Be sure system is connected to a
circuit equipped with a fuse or
circuit breaker of proper size.
NEVER leave the control box,
fused disconnect switch,
or covers open (either partially or
completely) when not being worked
on by a competent electrician or
repairman.
Always disconnect power source
before performing any work
on or near the motor or its connected
load. If the power disconnect point is
out-of-sight, lock it in the open position
and/or tag it to prevent unexpected
application of power. Failure to do so
could result in fatal electrical shock or
bodily injury.
B
Figure 6 - Control Center Schematic
Operating Instructions and Parts Manual