EUCHNER TZxxxAS1 - Manual (Page 8)

Operating Instructions Safety Switches TZ...AS
1
EUCHNER GmbH + Co. KG Kohlhammerstraße 16 D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 Fax +49/711/75 33 16 www.euchner.de [email protected]
Status table
Programming State D0, D1 D2, D3 Monitor diagnosis
Safety guard closed, guard locking active Code sequence Green
Guard locking open Half-seq. 00 Yellow flashing
2-channel Invalid state
00 Half-se.
Red flashing
conditionally dependent (safety guard open, guard locking active) (monitoring of the invalid state)
Safety guard open 00 00 Red
Address 0 or communication disrupted – Gray
Safety guard closed, guard locking active Code sequence Green
Guard locking open Half-seq. 00 Red
2-channel Invalid state
00 Half-seq.
Red
independent (safety guard open, guard locking active) (monitoring of the invalid state)
Safety guard open 00 00 Red
Address 0 or communication disrupted – Gray
Green if safety guard was previously open or
Safety guard closed, guard locking active Code sequence yellow flashing after startup,
if only guard locking was open.
2-channel
Yellow flashing,
dependent
Guard locking open Half-seq. 00 if guard locking was previously closed.
Synchronization time
Red if safety guard was previously open.
infinite
∞ ∞ ∞ ∞ ∞
Invalid state
Yellow flashing,
(safety guard open, guard locking active)
00 Half-seq. if safety guard was previously closed.
Red if safety guard was previously open.
Safety guard open 00 00 Red
Address 0 or communication disrupted – Gray