ETC Source Four CE Mini - Manual (Page 9)

6 Source Four Mini User Manual
Colour Frame Holder
The Source Four Mini comes equipped with a 70mm colour frame, which is a metal
frame used to hold colour media (often referred to as gel) in front of the lens. The
colour frame holder is equipped with a retaining clip that prevents the colour frame
from falling out.
Step 1: Release the retaining clip by gently
pushing it up.
Step 2: Insert the colour frame.
Step 3: Lock the retaining clip by gently pushing it
down.
Additional accessories are available for the Mini that
also fit into the colour frame holder. Those
accessories are top hat, short top hat, half hat, short
half hat, and donut. When an accessory is used, the colour frame should be
installed in the rear slot of the holder.
WARNING: Make sure the colour frame is locked in position with the
retaining clip.
N o t e : The colour frame should be inserted open side down.
2.54cm Diameter
Gobo Pattern Projection
The Source Four Mini has a gobo holder slot on the
top side of the shutter barrel, in front of the shutter. It
accommodates a E-size (37.5mm with a 25.4mm
image area) gobo pattern holder.
Use an optional donut in the colour frame holder to
enhance pattern projection.
When the slot is not in use, a small sheet metal cover
secured with a Phillips screw prevents light leakage.
Step 1: Use a Phillips screwdriver to loosen the
screw on the slot cover. Do not remove the
screw.
Step 2: Slide the cover completely forward to
expose the slot.
Step 3: Insert the gobo holder.
Step 4: Slide the slot cover back toward the
shutters until it meets the handle. Leave
enough space to move the handle.
Step 5: Secure the slot cover by tightening the
screw.
Shown at
actual size.
Retaining
clip
Colour
Frame
Holder