Eschenbach Optik Eclipse Touch - Manual (Page 5)

Page 3
Using the Eclipse Touch
1. Setting up
Lift the Eclipse Touch from its packaging
and place it on a solid, level desk. Raise
the screen upright.
Plug the power adapter into the mains
using the lead provided and insert the
other connector into the socket on the
rear bulkhead of the Eclipse Touch.
Ensure the unit is placed at least 10cms
(4 inches) back from the edge of the
desk. Sit in front of the unit.
Press the red button on the right of the
front panel to turn the Eclipse Touch on.
The Eclipse Touch will beep to indicate power-on and the lamps will
light. After a few seconds, the image will appear on the screen.
Release the brake on the reading
table and pull the table out towards
you. If you push the table back in
again, you will see that the table
locks home only when located
centrally between its legs. Place
some text on the table and you
should see it on the screen.
2. Folding down and moving
Turn off the unit and unplug the power adapter from the Eclipse Touch
and also from the wall socket. Remove all material from the reading
table, park the table centrally between its legs and apply the brakes.
Fold the screen back.