Eberspacher EasyStart T - Manual (Page 6)

6
Flashing symbols
Each flashing symbol
in the menu, program
and display bar can be
changed with or and
confirmed with .
Operation and Adjustment
Basic operation and adjustment rules
Activate timer
If the display is not lit, the timer must be
activated before each use.
The timer must be activated before each
operation or adjustment.
To do this, press until the menu bar
appears in the display, then release the
key and continue with the operation or
adjustment (see also page 7).
Confirm input
Settings and changes must always be
confirmed with , otherwise they are lost
(exception: operating time).
Terminate / quit settings
You can use to terminate or quit enter-
ing settings in a menu.
Set operating time
(one-off or permanent)
The operating time can be individually set
with or .
In preset mode from 10 – 120 minutes.
In immediate operation from 10 – 120
minutes or continuous operation .
See pages 8, 9, 11 and 14 for a descrip-
tion.
Display if a temperature sensor is
connected.
If the optional tempera-
ture sensor is connected
the time and temperature
can be alternately dis-
played by pressing .
In the settings and opera-
tions described below it
is assumed that a temperature sensor is
connected. Display disappears
If the vehicle lighting is switched off, no
heater or additional unit is switched on,
or no setting or actuation is made, the
display disappears within 10 seconds, i.e.
the timer switches to idle state.
For renewed input you must press
again.