Eberspacher EasyStart T - Manual (Page 13)

13
Operation and Adjustment
After the heater has been switched off in
“ventilate” mode, you can immediately
switch to “heat” mode using the “heat /
ventilate” switch or the “mini controller”.
Then use the timer to switch the heater
back on.
Switch of “ventilate” or “heat” mode
Use the timer to switch off the heater (see
page 12 resp. 10).
• “Ventilate” or “heat” mode must be
selected before switching on the
heater.
• In the “ventilate” switch setting of
HYDRONIC water heaters the vehicle
blower is directly controlled by bypass-
ing heat mode and in AIRTRONIC air
heaters the heater’s blower is bypassed
in the same way.
• If you have any further questions regard-
ing “ventilate” mode please contact your
installation workshop or call the service
phone number (see page 24).
General notes on ”ventilat“ mode
If the symbol is not displayed in the
menu bar, „ventilate“ mode is only pos-
sible in the heater for the heater models
under certain prerequisites:
• With the water heaters HYDRONIC
(B / D 4 W S, B / D 5 W S,
B / D 4 W SC and B / D 5 W SC): the
“heat / ventilate” switch (Order No. 22
1000 31 89 00) must be installed.
• With the air heaters AIRTRONIC /
AIRTRONIC M: the mini controller
(Order No. 22 1000 32 07 00) must be
installed.
“Ventilate” mode is not provided for
upgraded independent heaters.
Select „ventilate“ or „heat“ for the
heater models listed above and
switch on.
Use the “heat / ventilate” switch or the
mini controller to select “ventilate” or
“heat” mode and then switch on the
heater with the timer.
Switching between “ventilate” and
“heat” mode
If you switch mode while “ventilate” or
“heat” is running, you must use the timer
to switch of the heater (see page 12 and
10).
If the heater is switched off in “heat”
mode the heater runs on. Once this after-
run has ended use the “heat / ventilate”
switch or the “mini controller” to switch to
“ventilate” mode. Then use the timer to
switch the heater back on.
Please note!
Please note!