Eberspacher EasyStart T - Manual (Page 22)

22
What to do if …?
Description Remedy
A fault occurs in the heater during opera-
tion (e.g. fuel shortage or interruption in
the diagnostics cable). See heater’s installation instructions for
troubleshooting advice.
Description
The ”Set timer“ display appears after the timer is activated.
Possible cause Remedy
The timer’s power supply was interrupt-
ed. All programmed preset times have
been deleted. Set time (see page 8).
Displays
Description
Automatic hardware detection is currently active.
Possible cause Remedy
Timer has been disconnected from the
voltage and reconnected. Wait until the automatic hardware detec-
tion has finished.
Description
No communication between the controls.
Possible cause Remedy
Overlapping during data transfer Repeat operator action.
(only for combinations of 2 controls EasyStart T / T, R+ / T, R / T)