Doug Fleenor Design ColorWheel - Manual (Page 5)

Page 5 of 5
Advanced Operation
The Color Wheel has some simple fade effects built in. To activate these effects, turn
on the station and then push and hold the square mode button. After about three
seconds, the center LED on the Color Wheel will turn blue and a simple fade effect will
begin (red, green, blue, red, etc.). The encoder wheel now controls the speed of the
fade. Turn the encoder clockwise to speed up the fade and counter-clockwise to slow it
down. The station can be turned on and off in this mode using the encoder wheel
button.
While in the fade mode described above, you can push and hold the square mode
button for about three seconds again. The center LED on the Color Wheel will turn red
and a two color fade effect will begin. In this effect, two of the three colors will be on at
all times. The encoder wheel will control the speed of the fade just as it did in the single
color fade effect above.
Pushing and holding the square mode button for three second once more will return the
Color Wheel to its normal operating mode.
Warranty
Products manufactured by Doug Fleenor Design carry a five year warranty. If the
product breaks within five years of manufacture, Doug Fleenor Design will repair it. It is
the customer's responsibility to return the product to Doug Fleenor Design (at the
customer's expense). Doug Fleenor Design will repair the unit and return it to the
customer (at Doug Fleenor Design's expense). If a trip is necessary to the customer's
site to solve a problem, the expenses of the trip must be paid by the customer.