Deutz-Fahr Agrovector 35.7 - Manual (Page 98)

Section 5 - Attachments and Hitches
5-20 31200570
Fork Extension
Description P/N
Fork Extension, 50x100 mm ......................................1001112559
Use Appropriate Carriage Attachment Capacity Chart
To determine maximum capacity, refer to “Telehandler/Attachment/Fork Capacity” on
page 5-2. The maximum capacity of the carriage when equipped with fork
extensions may be reduced to the capacity indicated on the fork extensions. If the
load exceeds the capacity of the fork extension contact JLG to obtain forks and/or
fork extensions of the proper load rating and length.
The joystick (1) controls lift/lower and extend/retract movement of the boom.
The attachment tilt roller switch (2) controls fork tilt.
• Push roller switch down to tilt up.
• Push roller switch up to tilt down.
Installation Procedure:
• Ensure carriage is properly installed. Refer to “Attachment Installation” on
page 5-7.
• Ensure length and cross section of the parent fork arm is equal to or exceeds the
parent fork arm blade length stamped into the fork extension.
• Secure the fork extensions to the forks by sliding the fork extensions onto the
parent forks and install the retaining pin behind the vertical shank of the fork.
OZ0750
OAH1690
1 2