Deutz-Fahr Agrovector 35.7 - Manual (Page 107)

Section 5 - Attachments and Hitches
5-29 31200570
To Open/Close Bucket:
The auxiliary hydraulic buttons control the open/close movement of the bucket.
• Press and hold button (3) to close bucket or press and hold button (4) to open
bucket.
OR
• While pressing and holding button (5), move joystick forward to close bucket or
move joystick back to open bucket.
Installation Procedure:
• Refer to “Attachment Installation” on page 5-7.
Operation:
• Raise or lower boom to appropriate height and close bucket for loading material
from stockpile.
• Align telehandler with face of stockpile and drive slowly and smoothly into pile to
load bucket.
• Tilt bucket up far enough to retain load and back away from pile.
• Travel in accordance with requirements set forth in Section 1 - General Safety
Practices.
• Open bucket or tilt bucket down to dump load.
Equipment Damage Precautions
• Except for lifting or dumping a load, the boom must be fully retracted for all
bucket operations.
• Do not corner-load bucket. Distribute material evenly within the bucket. Bucket
capacity charts are for evenly distributed loads only.
• Do not use bucket as a lever to pry material. Excessive prying forces could
damage bucket or machine structure.
• Do not attempt to load material which is hard or frozen. This could cause severe
damage to quick attach or machine structure.
• Do not use bucket for "back dragging." This could cause severe damage to quick
attach.