Deutz-Fahr Agrovector 35.7 User Manual
Page 41
Section 3 - Controls and Indicators
3-7
31200570
9. Menus: Menus display fault codes and other machine information while allowing
modification of some operating parameters. Depress and hold the C and OK
buttons on the keypad to access menus.
a. Help - Displays active fault code. Depress OK button again and use keypad
arrows to cycle through the last 25 fault codes. Active faults are denoted with
an asterisk.
b. Operator Tools - Speed, Temperature and Oil Pressure units, Steering
Change Mode and Tires can be modified by the operator. Customer or
Service level access code required to modify additional items.
• Machine Speed - Select units (km/h or m/h) to be displayed.
• Engine Temperature - Select units (Celsius or fahrenheit) to be
displayed.
• Steering Alignment Mode - Select mode (manual, rear wheel assisted or
all wheel assisted, if equipped) to be used when changing steering
modes, see page 3-26.
• Tires - Select tire size installed on machine.
c. Personalities - View performance parameters. Customer or Service level
access code required to modify parameters.
d. Access Level - Code entry determines access level.
• Operator (Level 3) - No code required.
• Customer (Level 2) - See Service Manual for information.
• Service (Level 1) - Manufacturer service representative only.
e. Diagnostics - View diagnostic information.
f. System Test - Performs test of all system inputs and outputs.
g. Machine Setup - View machine configurations. Service level access code
required to modify configurations.
h. Calibrations - Customer or Service level access code required.
OAH2000
MENU:
HELP: PRESS ENTER
9