Deutz-Fahr Agrovector 30.7 - Manual (Page 92)

Section 5 - Attachments and Hitches
5-20 31200114
Fork Extension
Description P/N
Fork Extension, 50x100 mm ......................................1001112559
Use Carriage Attachment Capacity Chart
To determine maximum capacity of the carriage, refer to “Telehandler/Attachment/
Fork Capacity” on page 5-2. The maximum capacity of the carriage when equipped
with fork extensions may be reduced to the capacity indicated on the fork
extensions. If the load exceeds the capacity of the fork extension contact JLG to
obtain forks and/or fork extensions of the proper load rating and length.
The joystick (1) controls lift/lower movement of the boom and fork tilt.
• Move joystick left to tilt up.
• Move joystick right to tilt down.
The rocker switch (2) located on the boom joystick controls the extend/retract
movement of the boom.
Installation Procedure:
• Refer to “Attachment Installation” on page 5-7.
• Ensure length and cross section of the parent fork arm is equal to or exceeds the
parent fork arm blade length stamped into the fork extension.
• Secure the fork extensions to the forks by sliding the fork extension onto the
parent fork and install the retaining pin behind the vertical shank of the fork.
OZ0750
OAH0301
2
1