Deutz-Fahr Agrovector 30.7 - Manual (Page 46)

Section 3 - Controls And Indicators
3-12 31200114
Joystick
Refer to the joystick decal located inside the cab to know which control pattern your
machine is equipped with. Ensure the joystick decal matches the machine controls
before operating.
Loader Joystick Pattern (Before S/N 1160001327)
The joystick (1) controls the boom and attachment functions.
Boom Functions
• Move the joystick back to lift boom; move joystick forward to lower boom. Extend/
retract is controlled by the rocker switch (2). Push the rocker switch up to extend
boom; push the rocker switch down to retract boom.
• The speed of boom functions depends upon the amount of joystick travel in
corresponding direction. Increasing engine speed will also increase function
speed.
• For two simultaneous functions, move the joystick between quadrants. For
example; moving the joystick forward and to the left will lower boom and tilt
attachment back (up) simultaneously.
WARNING
TIP OVER/CRUSH HAZARD. Rapid, jerky operation of controls will cause rapid,
jerky movement of the load. Such movements could cause the load to shift or fall
or could cause the machine to tip over.
OAH0192
3
2
1