Deutz-Fahr Agrovector 30.7 - Manual (Page 118)

Section 7 - Lubrication and Maintenance
7-14 31200114
Tires
A. Tire Air Pressure Check
1. Perform “Shut-Down Procedure” on page 4-3.
2. Remove valve stem cap.
3. Check tire pressure using a good quality gauge.
4. Add air if required.
405/70-20 (26.6LP, 26.6 & 30.7) ........................................3,5 bar (51 psi)
405/70-24 (26.6 & 30.7) .....................................................4 bar (58 psi)
17.5-24 (30.7).....................................................................2,2 bar (32 psi)
12.5-18 (26.6LP) ................................................................5 bar (73 psi)
5. Replace valve stem cap.
B. Tire Damage
For pneumatic tires, JLG recommends that when any cut, rip or tear is discovered
that exposes sidewall or tread area cords in the tire, measures be taken to remove
the JLG product from service immediately. Arrangements must be made for
replacement of the tire or tire assembly.
C. Tire and Wheel Replacement
JLG recommends a replacement tire to be the same size, ply and brand as originally
installed. Refer to the appropriate parts manual for ordering information. If not using
a JLG approved replacement tire, JLG recommends that replacement tires have the
following characteristics:
• Equal or greater ply/load rating and size of original.
• Tire tread contact width equal or greater than original.
• Wheel diameter, width and offset dimensions equal to the original.
• Approved for the application by the tire manufacturer (including inflation pressure
and maximum tire load).
Unless specifically approved by JLG, do not replace a foam filled or ballast filled tire
assembly with a pneumatic tire. Due to size variations between tire brands, when
selecting and installing a replacement tire ensure both tires on the axle are the
same.
The rims installed have been designed for stability requirements which consist of
track width, tire pressure and load capacity. Size changes such as rim width, center
piece location, larger or smaller diameter, etc., without written factory
recommendations, may result in unsafe condition regarding stability.
8
OW1150
OW1040