Despatch RAD1-42-2E with Protocol Plus - Manual (Page 55)

47
Real Time Clock
Menu Item Display Default Range Setting
Day of the week Clock Day Mon Sun, Mon, Tue,
Wed, Thu, Fri, Sat
Time of day Clock HH:MM 00:00 00:00 to 23:59
Reset clock Clock UP to Reset CLK* Ready Ready, Done
* if the
key is not pressed, the clock values will retain their original values, the display
will change to Done if the clock is reset
Relay Outputs (optional)
Push Select key to select relay. If Relay 0 appears, no relays are installed
Menu Item Display Default Range
Type of relay Relay 1 RelayType Off Off, Alarm, Cycl, Ev1 to Ev4
Action of relay Relay 1 RelayAction NDE NDE, NE, NDEL, NEL*****
Type of alarm* Relay 1 AlarmType High High, Low, Plus, Minus, Band
Alarm setpoint* Relay 1 AlmHi/Lo SP 538°C -73°C to 760°C (-100°F to 1400°F)
Alarm deviation* Relay 1 AlmDevBand 3°C 1 to 56°C (1 to 100°F)
Inhibit alarm* Relay 1 ALMInhibit On En or Dis
Type of event** Relay 1 EventType Time Time or Temp
Event setpoint *** Relay 1 Event SP SPUpLim SPLoLim to SPUpLim****
(repeat for relay outputs 2-4, if available)
* appears only for alarm types
** appears only for time or temperature event types
*** appears only for temperature event types
**** see enable page
***** Normally de-energized and non-latching, normally energized and non-latching,
normally de-energized and latching, normally energized and latching
Table of Settings
Relay Type Action Alarm/
Event Type Setpoint Alarm
Deviation Alarm
Inhibit