Dascom 1430 User Guide - Manual (Page 32)

Tally Dascom 1430
18
Self Test /
Status Page [S1] -
Prints the printer settings and self-test pattern.
Service Menu [S3]+[S4] - Vertical Alignment, Change Pin Function and Endless Self
Test
Adjust Page
Margins [S1]+[S2] - Includes Adjust Fanfold Top Margin, Adjust Single Top
Margin, Adjust Fanfold Left Margin, Adjust Single Left
Margin and Adjust Tear-Off position.
Restore Factory
Defaults [S1]+[S2]+[S3] - Restore settings to factory defaults except for Change Pin,
Vertical Alignment and Adjust Page Margin Parameters.
Firmware
Update [S1]+[S2]+[S3]+
[S4] -  Alternate flashing of L1 and L2 indicates ready for
firmware update from host.
 When new firmware is being received: L1 and L2 will
flash together, then followed by L1 and L3 flashing
together.
 When downloading is completed, the carriage returns
to home position. Printer initializes normally.
Language
Setup
[S2]+[S3]
 Allows user to select one of the following languages:
English, German, Russian, Italian, French, Spanish
and Turkish. Factory default is English. Refer to
Language Setup section below for details.
Language Setup
The panel menu can display the following languages: English, German, Russian, Italian, French, Spanish and
Turkish. Factory default setting is English. To change it to another language, hold down the [LF/FF] and
[Load/Eject] keys on the panel and power-on. Upon exiting the Language Setup Menu, a listing of the current
configuration is printed, and this is followed by Main Menu Setup.
Below is an example of changing from English to German language: