Dascom DM-220 User Guide - Manual (Page 32)

Tally Dascom DM-210/220
20
5 Specifications
5.1 Printer Specification
Print Parameter
Print method 9 pin dot matrix (Pin
∮
0.30mm)
Print direction bidirectional logic-seeking
Resolution max 160dpiH x 144dpiV
Print speed 4.3lps (4.3 line / sec at 42 columns)
Paper feed speed max 5.51ips (14cm/s)
Print width 42cpl @ 16.7cpi (7x8 matrix)
Interface
Cash drawer: DC 24V, 1A, 6 line RJ-11 connector
USB 2.0: Full Speed, standard type B Connector
Serial RS232C: 25-pin Sub-D (f) connector; supports DTR or
XON/XOFF handshaking protocol; baud rate 4800~38400BPS;
data Format 1 initial bit + 8 data bit + 1 or 2 stop bits, no Parity.
Parallel CENTRONICS: 25-pin Sub-D (m) connector, 8-bit
parallel; supports BUSY/ACK handshaking protocol.
Power Sleep Supported
Ribbon Lifetime
NH37701 (Purple)：3000,000 characters(Compatible to ERC-39)
NH37703 (Black)： 1000,000 characters
Copies 1+1 (Thickness: 0.05~0.08mm/page; Total thickness: ≤0.16mm)
Memory
Flash 2Mbytes
RAM Max. 32Kbytes data buffer
Fonts
Chinese GB18030_2000 16x16
Alphanumeric 7x8 and 9x8 ASCII font
Code page
PC437 /PC850 /PC860 /PC863 /PC865 /PC858 /PC862 /PC737
/PC857 /PC866 /PC864
Detect Function Sensors Black mark sensor, paper end sensor
Key and LED Indicator
Key Feed key
Power indicator Green LED
Paper indicator Red LED
Error indicator Red LED
Power Supply
External power adapter
Input AC 100V-240V 50-60Hz
Output DC 24V±5%, 2.1A
Paper
Paper type Good quality normal white roll paper or carbonized roll paper
Paper width 76.2±0.5mm (3 inch)
Paper thickness 0.06～0.085mm for single paper
Paper roll diameter
Max. OD
∮
83mm
ID
∮
10+2/-0mm
Paper load
Automatical load in paper end condition when paper is inserted
into the paper path.
Paper cut
DM-210: Manual tear;
DM-220: Auto-cutter; support full cut and partial cut.
Full cut (Cuts the paper completely)
Partial cut (one point left uncut in center position)
Note: The point length is 2% of the paper width.
Paper Feed Friction feed