Installing a crimp-on telephone pulling eye – Condux Crimp-On Pulling Eyes User Manual
Page 7
A. PREPARING THE CABLE - THE CENTERING TOOL
First, it is recommended that you square off the end of the cable. This ensures that the pulling
eye will go on as far as possible.
From the chart below, locate the proper centering tool. Place the centering tool on the end of the
cable as close to the center as possible. Drive the centering tool into the cable up to the head of
the centering tool. This will push some of the grease from the cable and separate the wire pairs,
making way for the spike inside of the pulling eye.
Cable O.D.
Up To (in.)
Cable O.D.
Up To (mm)
Centering Tool
Part Number
Cable O.D.
Up To (in.)
Cable O.D.
Up To (mm)
Centering Tool
Part Number
1.055
27
08945011
2.402
61
08945027
1.152
29
08945011
2.527
64
08945027
1.277
32
08945015
2.652
68
08945027
1.402
36
08945015
2.777
70
08945027
1.527
39
08945015
2.902
74
08945029
1.652
42
08945021
2.995
76
08945029
1.777
45
08945021
3.140
79
08945034
1.902
49
08945021
3.245
83
08945034
2.027
51
08945021
3.370
86
08945034
2.152
55
08945021
3.495
89
08945034
2.277
32
08945027
3.620
92
08945043
2.
Installing a Crimp-On Telephone
Pulling Eye
7