Condux Crimp-On Pulling Eyes - Manual (Page 11)

Insert the ferrule on one end of the crimper cable into the pocket in the base. The cable should
then pass up through the die. Make a loop with the cable and pass the cable back down through
the slot on the opposite side of the die. Then insert the ferrule into the other pocket in the base.
Bring the retaining ring back up tight against the base of the crimper cable and tighten the
setscrew. This locks the cable into the base.
With the cable in place, snap the crimper die out of the ram and lift it away slightly. Do not lift it
out from between the crimper cable. Install the guard by slipping it over the shoulder pins and
thumb screws in the base. Pull up on the guard and tighten down the two thumb screws. Snap
the crimper die back into the ram.
Attach the hose from the crimper ram to a 10,000 psi hydraulic pump. Once the pump is attached
to the ram, cycle the ram a couple of times to make sure everything is in proper working order.
You are now ready to crimp the pulling eye onto the cable.
11