Condux Crimp-On Pulling Eyes - Manual (Page 5)

B. CRIMPER KIT AND ACCESSORIES
Items needed to crimp pulling eyes onto cable:
1. The Crimper Kit - The kit has capabilities of crimping pulling eyes with inside diameters of 0.555
to 3.620 inches. The kit contains the crimper dies, crimper cables, crimper base and hydraulic
ram, cable guard, and the hydraulic hose and couplings. Condux part number 08920000.
2. Driving Tool - The driving tool is used for driving the pulling eye onto the cable. This is an
important tool to keep the pulling eye from being damaged during installation.
3. Centering Tool - By driving the centering tool into the end of the communications cable, you
force some of the grease out and separate the wire pairs. This provides a passage in the center
of the cable for the pulling eye spike to follow into.
4. Hydraulic Pump - The pump is used to supply hydraulic pressure to the crimper ram which
crimps the eye to the cable.
5. Measuring Tape - The measuring tape is used for determining the size of the cable and for
ensuring complete seating of the eye on the cable.
6. Sledge Hammer - For driving the centering tool into the cable and for driving the pulling eye
onto the cable when using the driving tool.
5