CHAMPION CG6 Manual - Manual (Page 15)

13
MAINTENANCE
MAINTENANCE
CLEANING
Daily Cleaning Instructions
1. Clear the conveyor of glassware and turn glasswasher off by flipping the toggle switch
located on the wash tank to the “off ” position.
2. Remove load and unload end pick-up plates and splash curtains. Wash them with hot soapy
water, rinse thoroughly, then dry.
3. Lift and remove spray hood and set it aside.
4. At right hand side of machine, raise conveyor lift bracket to stop position. Remove any
debris from catch pan located below spray tubes and in area surrounding overflow tube.
5. Remove overflow tube at right side of upper tank area. Starting at the left side of the
machine, flush all debris from left to right side of machine using a wash down nozzle.
NOTE:
Do not leave water in tank overnight!!!
6. Replace overflow tube, lower lift bracket to adjusters and ensure brackets are solidly
engaged over track adjusters.
7. Replace spray hood, ensuring hood hose connections are firmly engaged. Replace curtains
and pick-up plates.
8. Remove and clean upper and lower wash tank screens. Remove standpipe from the
detergent tank; wash down then rinse the interior of the detergent tank.
9. Replace stand pipe. Replace both upper and lower screens.
10. Ensure there is product in the detergent, sanitizer and rinse agent containers. Close doors.
Weekly Cleaning Instructions
1. Lift and remove front spray-hood cover and open front doors. Remove upper and lower
manifold end caps and clean spray tubes with reamer, tube brush, and tube scraper
provided.
2. Remove detergent, sanitizer, and rinse agent feed lines from containers and place them in a
container of hot water. Hold prime buttons in until the feed lines have been thoroughly
flushed. Replace the feed lines to their proper container and prime product through lines.