Caron 6017 - Manual (Page 50)

6010 Series Operations Manual Rev E 2/14/2012 Page 50 of 68
Operation of Side Mounted Recorders (RCDR311, RCDR312)
Side mounted Honeywell DR 4300 General Purpose Circular Chart Recorders are also
available with CARON chambers. This chart recorder uses reliable microprocessor
operation to generate dependable pen drawn analog traces on preprinted 10-inch (250
mm) charts. The two-pen model accepts inputs from a temperature sensor and a
humidity sensor. The single-pen model records temperature only. The recorders are
housed in a molded case with a glass windowed, gray gasketed door which protects
internal components while allowing easy access to the chart.
Routine Maintenance:
The recorder does not require any periodic maintenance. However, the chart and ink
cartridges will have to be replaced as required.
Replacing the Ink Cartridge:
Refer to Figure 8 in the Honeywell manual: Replacing the Ink Cartridge and Chart.
1. Remove power from recorder. Push in the button on the door and swing the door
open.
2. Pull up on the pen lifter to raise the pens from the chart plate. NOTE: DO NOT LIFT
THE PENS DIRECTLY
CAUTION: Be careful not to move the pen arm while removing and installing the ink
cartridge. The longer pen arm is pen #1
3. Unclip and remove the purple (Pen #1) or red (Pen #2) ink cartridge for the pen arm.
4. Remove the protective cap from the pen tip on the new cartridge and open its clip.
5. Slide the new cartridge onto the pen arm so that its tip fits into the notch at the end of
the pen arm and close the clip to secure the cartridge to the pen arm.
6. Push down the pen lifter to return the pen tip to the chart.
7. Close the door and apply power.
Replacing the chart:
Refer to Figure 8 in the Honeywell manual: Replacing the Ink Cartridge and Chart.
1. Remove power from recorder. Push in the button on the door and swing the door
open.
2. Pull up on the pen lifter to raise the pens from the chart plate. NOTE: DO NOT LIFT
THE PENS DIRECTLY
3. Lift the chart from the hub and locating pin and slide it from under the pens to remove
it from the chart plate.