Caron 6016 - Manual (Page 26)

6014 & 6016 Operations Manual Rev C 2/14/12 Page 26 of 56
Changing the CO
2
Set-point
If an alternative CO
2
set-point is required, the following steps can be taken:
Press the up arrow to increase the CO
2
set-point by 0.1% CO
2
. Press the down arrow to
decrease the CO
2
set-point by 0.1% CO
2
. Pressing and holding either button will cause
the set-point to scroll rapidly in either direction.
If CO
2
is not required in the incubator, the CO
2
system can be disabled by turning off the
Enable CO
2
switch. This will disable the entire CO
2
system including the controller. The
system can be turned back on at anytime.
CO
2
Set-
point
Increase CO
2
Set-point
Decrease
CO
2
Set-point
Enable CO
2
Actual CO
2