Caron 6016 - Manual (Page 19)

6014 & 6016 Operations Manual Rev C 2/14/12 Page 19 of 56
Installing Carboy Water System (BOTL301)
The optional 2.5 gallon carboy water system is preassembled and shipped inside the
incubator
. The four ¼” bolts required to mount the carboy to the unit will be mounted in
the right hand side of the incubator. Remove the carboy assembly from inside the
incubator and attach it to the incubator
using the ¼” bolts.
Attach the preassembled tubing provided with the carboy to the water inlet on the rear of
the incubator. Fill
the carboy with water as described in the “connecting a water supply”
section of the manual.
¼” Bolts
(4 total)
Tubing connects/
disconnect to
carboy