Caron 6016 - Manual (Page 25)

6014 & 6016 Operations Manual Rev C 2/14/12 Page 25 of 56
Changing the Humidity Set-point
If an alternative humidity set-point is required, the following steps can be taken:
Press the up arrow to increase the humidity set-point by 1% RH. Press the down arrow
to decrease the humidity set-point by 1% RH. Pressing and holding either button will
cause the set-point to scroll rapidly in either direction.
If humidity is not required in the incubator, the RH system can be disabled by turning off
the Enable Humidity switch. This will disable the entire RH system including the
controller. The system can be turned back on at anytime.
At humidity levels above 80%, condensation forming on the door is normal.
Humidity
Set-point
Actual
Humidity
Increase
Humidity
Set-point
Decrease
Humidity
Set-point
Enable
Humidity