Caron 6047 - Manual (Page 12)

6020 & 6040 Series Operations Manual Rev E 2/14/2012 Page 12 of 66
SECTION 3 – INSTALLATION
Unpacking
Your new unit has been thoroughly packaged to avoid shipping damage. However,
the unit should be fully inspected upon arrival before signing for receipt. If the package
has visual damage, notes should be made on the freight bill and signed by the delivery
company. In the event of concealed damage after the unit is uncrated, keep the carton
and packaging material. Call the shipping company within 7 days of receipt, request
inspection and retain a copy of the inspection report.
Caron provides full on-site installation services for all models. Our installation services
guarantees the proper set-up and startup of all equipment. Please contact the Service
Department at 740-373-6809 or [email protected] for details.
Choosing a Location
To ensure proper operation, the unit must be located on a firm level surface, capable of
supporting approximately 800 pounds. The unit should be located in an 18°C – 25°C
ambient area and where there is no direct airflow from heating and cooling ducts as
well as out of direct sunlight. Allow four inches of clearance on all sides of the product
to allow for connections and airflow.
Model Water Source Needed Water Drain
6020 / 6040 Yes Yes
6021 / 6041 No *Yes
6022 / 6042 No *Yes
6023 / 6043 No No
6025 / 6045 Yes Yes
6027 / 6047 Yes Yes
* Depending on user set points, these units may not need a drain. Drains are
recommended at temperatures below 15°C.
The unit requires a dedicated electrical connection. Power requirements vary
depending upon the chamber model, see Connecting Electrical Power section.
This product weighs in excess of 500 pounds.
Ensure that sufficient resources are available to
safely move the product.