Online manual not for resale purposes – BLITZ Dual SBC Spec R & S User Manual

Page 9

Mode - M

Map Analyzer is not connected, this mode will stay at zero.

* The user must purchase the optional map analyzer unit to use this function.

Mode - Gain setting

This is used to adjust boost response and to lower boost spikes.

OPERATION INSTRUCTIONS

To set boost:

Push the mode button the number " 1 " will flash on the left.

EXAMPLE ONLY

MODE BUTTON

right. Then turn volume knob to desired ratio.

EXAMPLE ONLY

VOLUME BUTTON

C - Repeat steps A and B to set channels 2 - 4.

ratio low and slowly increase the ratio until the desired boost setting is achieved.

percentage set at low then slowly adjust to the desired setting.

This mode is for the optional Map Analyzer mode. When the

The gain setting adjust the boost sensitivity of the boost controller.

Setting the desired boost.
The DSBC allows the user to set boost at 4 different settings ( channels 1, 2, 3, 4 ).

A - Turn the mode button to channel 1. The number " 1 " will appear.

B - Push volume button until the " SET " appears on the

WARNING - the number boost setting displayed does not represent actual boost, it is a percentage ratio.
0 represents stock boost, 100 represents maximum turbo charger capabilities. Always start of by setting the

IMPORTANT - A boost gauge, an egt gauge, or an Air Fuel Analyzer should used when setting the
DSBC. The DSBC does not add fuel in any way. The user should always start with the boost

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No part of this may be

reproduced, stored in retrevial systems, or transmitted in any form or means with out prior written permission of

Blitz Co., Ltd. (Japan).

Online Manual Not For Resale Purposes